Pull the tab off the point of the hook, and then turn the tab to the left to slide it between the gap in the pigtail of the bridle wire. To create slack in the bridle strap, trip the jack with the middle finger of your left hand, while pushing and holding the backcheck forward with your thumb. To remove cork insert bridle straps, first pull the tab forward and upwards to loosen the tab from the hook of the bridle wire. Make sure to remove any residue that remains in the eye of the pigtail.ģ. Many times, the tabs of original bridle straps will simply crumble from the pigtail when pulled on, making for a very simple operation. Next, remove the tabs any remaining factory straps from the bridle wires by pulling the tab off of the pigtail of the wire. ![]() For any of the original straps which are already broken, grasp the broken end of the cord with a pair of needle nose pliers, and cut the remaining cord as close as possible to the hammer butt.Ģ. Use a Precision Knife to cut the cord between the hole in the catcher and the hammer butt. Don’t push too hard or you will break the old cord. To tighten a strap to make cutting easier, push forward on the catcher with the thumb of your left hand, while pushing backward on the backcheck felt with your middle finger. ![]() If any such straps are still complete, they are easier to cut if pulled slightly taut. If the original (factory) straps which passed through the hole in the catcher remain, first snip or cut the old cord in between the catcher and the hammer butt. Use the following steps when installing a set of bridle straps:ġ. If your set of bridle straps is incomplete or mismatched, replacement with an entirely new, correctly adjusted set is the best solution.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |